Frontpage Products Fast-setting screeding mortar "Mix" PlaneMix S40

PlaneMix S40

Pool and concrete repair mortar

Ideal for leveling/straightening in pools
For patch repair and re-profiling of all concrete types,
such as footings, balconies, and staircases
For wall and floor (vertical and horizontal use)
For interior and exterior use
Shrinkage compensation system and fibre-reinforced
High adhesion and compressive strength
Excellent application properties
Layer thickness 5 - 40 mm

Product calculator

Calculate

Retailers

Product information

Application

Surfaces

Concrete

Surface preparation

All surfaces should be structurally sound and clean, free from dust, grease, salt, dirt, and other contaminations.
Damaged concrete should be removed.
Depending on surface condition, grit or high water pressure blasting may be required. Cohesion strength should be ≥ 1.5 N/mm²
Possible reinforcing steel should be corrosion resistant.
To improve adhesion and ensure optimum result, always apply bonding coat of Alfix PlaneMix S40 and Alfix PlaneMixPrimer in the ratio 1:1.
Apply bonding coat by broom or large brush to full coverage.

How to use

For mixing use approx. 2.7 litre (floor) or 3.0 litre (wall) clean, cold water per 20 kg powder. Pour water into a clean container, sprinkle in powder while stirring until a lump free, smooth mixture is obtained. Use forced action pan mixer or suitable paddle attached to electric drill. Allow the mortar to rest for a few minutes, remix briefly and the mixture is ready for use.
Apply mortar onto damp substrate using trowel or screeding board within 8 hours after application of bond coat.

For large areas, use guide battens and levelling batten. Cut edges and joints in square angles to a min. depth of 5 mm to avoid weak overbridging.

Once the mortar has begun to stiffen, smooth and finish surface by float. Layer thickness: Max. 40 mm

NB!
Additional water should not be added to a mixture already starting to set.
Exterior work with should only take place in dry weather at temperatures from +5°C - +25°C. Avoid direct sunlight. If rainy weather or temperatures below +5°C are forecast, cover surfaces. Avoid exterior repairs and levelling during winter.

Cleaning

Clean residues from tools with water before the mortar sets. Cement-based products harden when mixed with water, hence do not dispose of excess material by pouring into drainage system.

Downloads

	Alfix A/S H.C. Oersteds Vej 11-13 DK-6000 Kolding alfix.com 14	Declaration of performance No. 38	EN 998-1:2010 Alfix PlaneMix S40 For external and internal use on walls CS IV
Reaction to fire	A1	Thermal conductivity	λ10,dry ≤ 0,83 W/ (m-K) for P=50% λ10,dry ≤ 0,93 W/ (m-K) for P=90% (EN 1745 table)
Capillary water absorption	W0
Water vapour permeability μ	≤ 25
Adhesion	≥ 0,08 N/mm²	Durability	NPD

PlaneMix S40

Product

Coverage

Packaging

Precautions

Technical data

Surfaces

Surface preparation

How to use

Cleaning

Guidance

Downloads

Product Info

EMICODE

EPD

Material Safety Data Sheet